Caliber MCD795 Guia de Resolução de Problemas descarregar pdf (Página 27)

When you open the menu manually, it will stay on until you close it or switch to

another screen.

Tip: If you want to see the map around the Cursor, close the Cursor menu and

reopen it. When this menu is opened manually, the map is always moved to have the

cursor in the centre.

The content of the Cursor menu depends on the screen (Map or Cockpit) and it is

slightly different if there is an active route already planned. You have the following

options:

• Start: use the Cursor as the departure point for your route. This menu point is

available only in Map mode and when there is no active route. In Cockpit mode

the departure point of the route is always the GPS position or if it is not available,

the last known GPS position.

• Route To: use the Cursor as the destination of your route. This button is to start a

new route. The previous route (if it exists) will be deleted and replaced. If a multi-

point route is active, This GPS device will ask you whether you really want to

delete it together with all its via points.

• Add Via: by inserting the selected map point as a via, you instruct this GPS

device to cross this location before the destination of the route. This is the way to

build a multi-point route in reverse order (when you wish to insert a stopover ‘go to

A but first get some fuel at B’ or want to influence the direction of the route). This

menu point works only if a route is already active.

• Remove Via: removes the ‘via point’ near or at the Cursor. The route will be

recalculated immediately excluding the deleted point. This menu point replaces

Add Via and is available only if the Cursor is near or at a via point.

• Continue: add a new destination to be reached after the previous destination. The

new destination replaces the old one, which is now demoted to a via point. This is

the way to build your multi-point route in straight order (when you wish to visit

several destinations ‘go to A then to B’). This menu point is available only if a

route is already active.

• Add Cam: this button will place a speed camera at the position of the Cursor. A

new window opens where you can set the type of the camera (fixed, mobile, built-

in, or section control camera), the direction of the monitored traffic (your direction,

the opposite direction, both directions or all directions), and the speed limit. If the

map contains speed limit information, this will be the default value for Camera

Speed.

• Edit Cam: you can edit the parameters of the camera near or at the Cursor, or

delete it. This menu point replaces Add Cam and is available only if the selected

point is near or at a speed camera. A window will open up that contains the same

settings as in Add Cam. In addition, it will have a Delete button that removes the

camera from the map.

• Add POI: opens the new POI capture window to let you add the selected map

point to the list of your user points. This menu point is only available on the Map

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 72 73

Sem comentários

Caliber MCD795 Guia de Resolução de Problemas Página 27